[Brule]

Drag racing setup below.

Getting close to having it driving.
Should have some videos of it running in the coming weeks.
Im down to some minor things

Transmission custom make a brace
Tighten converter, has a 3mm gap which i think is perfect
Hook up shifter cable to transmission
Make a hoop for driveshaft
Make a custom trans cooler setup
Shorten drive shaft. No one can do it in Darwin unfortunately.

Engine stuff
Make oil feed 100mm longer to avoid manifold better
Shorten chargepipe and blank off bov
Add meth bung on intercooler cold side
Get some silicone for intercooler joins
Wire clutch so it starts put wire 3 and 4 together i think

Figure out how to tune it