Quote:
Originally Posted by Bimmer_Engineer
Quote:
Originally Posted by Tyc0
Today I finished up my RB two and rod bearing job, and now when I drive it after about 2-3 minutes of driving it will go into limp mode. Codes are boost pressure control deactivation(3100) and knock sensor 2 (not sure the number). For the few minutes the car isn't in limp mode the car feels faster than it used to, and seems to run fine. I would post log but it was raining today. Seem a few people talk about some sort of dme software update that helped. Any ideas ?
|
I had the knock sensor before, a new sensor fixed it. I think the sensor code indicates that you have a bad sensor...if you had knock you would have a knock code... |
Unless a faulty sensor can make knock happen..it's 100% knocking