Quote:
Originally Posted by seetran
Quote:
Originally Posted by AGO 530
You need to drop the roof panel and release the dome/map assembly from the top. This will allow you to retrieve the white housing that the bulb will plug into. The white housing is "keyed" for the hole, one half turn and it will lock back into place. Install the new LED map light bulb into the housing and re-install the dome light back into the roof.
|
How do I drop the roof panel? Is there a diy for this?
|
You need to remove the snap-in clips that hold the sun visors to the roof (close to the dome light). Using a hook tool open the flaps, access the torx screws and remove. Open the sunroof and pull the rubber moulding back from the roof, just enough to reach inside and release the two clips on the front of the dome assembly near the windshield. It's tight, just feel around for the two metal clips similar to what you would find on the center dome light assembly. The dome assembly will drop from the front near the windshield, disconnect all of the wired connections, this will make it a lot easier to swap out the bulbs when the housing is removed from the vehicle.