Quote:
Originally Posted by mweisdorfer
The turner Motor mounts come with a ceramic spacer on the exhaust side only. I called ECS tuning and verified with them that this one was for the exhaust side. They stated that the ceramic plate was for heat transfer.
I could go back in and wrap that mount with DEI Gold Heat Tape, which is supposed to be good for 850 degrees. I have never tempted the exhaust manifold with an inferred gun to be higher than 500 degrees.
Your thoughts ?
|
Yeah, the plate will help with direct heat transfer just like phenolic spacer does for an aluminum intake manifold, but on the exhaust side radiated heat is an issue too and that will go straight into the aluminum housing around the poly which is where part of the issue will likely stem from. Look up what egts are from the N54.