View Single Post
      04-01-2020, 10:39 AM   #11469
colorado.e9x
Entrepreneur
colorado.e9x's Avatar
United_States
514
Rep
1,490
Posts

Drives: 06 BMW 330xi
Join Date: Feb 2018
Location: Western Slope, Colorado

iTrader: (0)

Quote:
Originally Posted by neilvan View Post
Quote:
Originally Posted by colorado.e9x View Post
Finished up the ram air intake. Unfortunately had to sacrifice the drivers brake duct due to having the ACS lip. I don't track the car so I don't think it'll be much of a problem.

I'll update the pics with what it looks like on the outside tomorrow. For now, here it is
What fittings did you use for the hose?

Also curious why you didn't dremel out the diamond pattern on the outer panel part or purchase the factory fully open panel that bmw sells(and dinan uses for their kits). Then you would keep your brake duct
Funny enough this whole project started because I found two unused desk hole grommets from my work. lol. Those are my fittings.

And I explained why I couldn't cut through outer panel in the original post