NFRM is the next version of the FRM module. FRM was used on early module cars. So in your case wherever the instructions say FRM, it's NFRM for you.
The last step in the VO DIY says to code another module, the NFRM and CAS are the modules that need to have the FA_write.
AFter doing that, you can recode the NFRM module.
Basically follow the original DIY to code in ncs expert. Select expertmode profile instead of FSW_PSW. Follow the same steps as before to the point where you complete reading the specific module (ie NFRM). After that, you don't need to go into the WORK folder and change the file around etc.
What you do is change the job to SG_Coderien (similar) and just code the module. This will make all the changes required for xenon.
After that, just disable AUTO_LWR_ENABLE.
That should be all you need to do.
|