|
Fitment Question
Hey Mike.
Back again as promised.
Ready to order - just need to make sure there will not be any install issues w/the ER-CP to a Helix FMIC?? I believe mine is the 2nd generation Helix - got it in a GB about 2 yrs ago. Only diff btwn original run to 2nd generation, was to eliminate some req'd cutting. I'm just not sure if the IC inlet position varies from stock??
Install was so long back, I can't remember.
Do you charge to have the meth bungs located on the elbow vs their current position (as pictured on site)? I'm not currently running a meth kit, but if I ever decide to, I'd prefer the lower location.
Ready when you are... Thanks!!
|