[gjm120]

I disassembled a trc file using NCS Dummy to change some values. The change took effect and was reflected in the Modules and Traces. Then when the file is exported to the Work folder the file only has the data value that was changed - not the full file.

Thought it might be something related to the dis and reassembly so tried just changing a value in Modules and Traces. Again same result - only the changed values are in the exported file.

Logic tells me if I coded this 99.99% empty file into the car, it would kill everything except the value in MAN file.

I am doing this as a dry run (not connected) just in case I mess up anything.