Quote:
Originally Posted by Maniac0908
Ya thats what im doing. The 4 channel is just for the underseat subs.
How should these be wired to the 4 channel. Ch. 1/2 or bridged and use all 4 channels? Settings?
The mono amp is going to be for my trunk sub. Sub is wires parallel for a 2ohm load. Settings for this?
Thanks
|
The underseats are 4 ohm so you can bridge them.
Start with a 60 hz high pass filter on the underseats and a 60hz low pass filter on the sub. Bass boost off, and gains should be set with a multimeter. Set the gain before setting the filters.
http://www.glasswolf.net/papers/dmmgain.html