View Single Post
      09-27-2008, 03:56 PM   #3
Major General

Drives: TS330iPPSP6MT
Join Date: Jul 2005
Location: Planet Earth

iTrader: (3)

Step 4. Behind the rectangular harness you will see additional wire tubing held on the underside of the cowling. Unclip those 3 clips and pull the wire tubing down

Step 5. Before you remove the cowling, unhook any other wiring that is still attached to the top side of the cowling. Now pull the cowling straight out toward the front of the car and tilt it up a bit as you pull (it helps to wiggle and work each corner loose as you go along).

Step 6. Remove the engine cover, pull the cover straight up and it will pop right out. The alternative would be to use a T-47 size torx screw and unscrew the five torx screws on top of the engine cover.

Now the coils are exposed.
Attached Images
under construction!

Last edited by txusa03; 09-27-2008 at 08:14 PM.