Quote:
Originally Posted by jammy78
What you need to do..... connect straight to the battery.
You don't neeed to worry about a remote as the fibre optic takes care of this!
The easiest way.... what I was going to do:
> red to the battery (add a inline fuse)
> brown to a earth
> run wires to the rear shelf speakers
> run remaining wires to the front of the car (going down the passenger side - connect the rear side panel speaker.
> remove the speaker wires that plug into the Hu or CIC. Then plug them into a connector.... Run the wires to this connector ='done,
> you'll be left with the centre speaker wire, which you plug into the speaker
This way, you don't need to run the wires to each speaker, as this is already done for you (back of the hu)
Simples
|
Cheers bud, managed to get some info from another thread so sussed out where the fuse is etc, might do what you've mentioned though and run off the battery if I can pull the wire back through without having to remove the back seats again etc. already run all the wires to the speakers bar the front doors and centre dash. Probably gonna splice into the existing speaker wires for the doors and connect that way.
Have you coded logic 7 before? If so, curious which module and setting I need to change, or is it the vehicle order I change?