Quote:
Originally Posted by Schmidty335i
I pulled my EEPROM and cleared the vin, all i did was change the 2E0 line from what it was to all FF's then put it back in my car. i got the tamper dot again so i know it cleared. i coded it to my car with NCS then the dot went away and i got the same error i always got. i just ordered some new M35080 eeprom chips that should be here in 2 weeks to see if maybe the EEPROM is bad?? do i need to write anything at all to them or just install it on the clusters mother board blank? will the car automatically write to it when i use NCS expert to code it? hopefully the new EEPROM works.
|
Did you blank out the whole 2E0 line? You can't use a blank Eeprom, it needs to be written first.