Quote:
Originally Posted by luckyu
It's possible to make the M3 bracket work without modification. The original rod is reused, and you only need to buy the M3 bracket (the thingy that screws in to the camber arm).
It may be necessary to finesse the sensor outboard, I am not 100% sure. It *is* necessary to flip the rod around 180 degrees. Here is a picture of my car, installed. Taken from behind the left rear tire, it shows the sensor arm (top) fastened to the original rod, and below picture is the M3 bracket:
Attachment 640216 |
I think your right. I made the custom bracket a few years ago but it may be the case that it is not required. As long as the sensor motion range is the same it should work fine or at least it is for you? I will give this a try myself...thanks.