To start off I rarely post here...I get most of my answers searching and reading before I need to ask... and I myself get frustrated with cluttering up the forum with the same questions over and over.
So, I just upgraded to Rev 2.5 and love the new maps.
I finally got around installing a used PWM kit from a member here.
Problem is when I went on my test run to do some pulls the only time I see my hazards flash is when I am letting up on the throttle (over 3500k) they just flash once and I know that meth is not flowing.
The kit I received was totally complete and barely used, it came with the upgraded pump also. I can jump the boost switch and the pump runs and it flows up to the charge pipe. I set the parameters as per the instructions in map 2 also. Set it to map 4... I purged the line from the washer bottle twice and triple checked for leaks and went through everything twice also.
Any help or direction would be appreciated. Thanks!