Quote:
|
Originally Posted by Mik325tds
Quote:
Originally Posted by gtp900
What did you do about metal shavings? Turbine and waste gate hole?
|
Most of the shavings will drop down on you while drilling. Definitely need eye protection for that. The only part to worry about are the shavings left on the other side of the waste gate when the drill goes through. I used a shop vac to clean the shavings. I figured the rest of the shavings will be pushed out by the exhaust gases. |
Thanks! Very informative posting, can't wait for it to warm up here to get this mod done
