|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
Codes after BMS DP Fix V3 - 2CA8 & 2CA9
|
|
02-18-2010, 10:06 PM | #1 | ||
Private First Class
6
Rep 198
Posts |
Codes after BMS DP Fix V3 - 2CA8 & 2CA9
Has anyone else had these codes pop up after the new BMS DP fix? I've been in touch with Terry, but he wasn't sure what it could be so I figured I'd give it a shot here ... anyone have any ideas?
Quote:
Quote:
__________________
Not Stock... |
||
02-18-2010, 10:19 PM | #2 |
Major General
160
Rep 5,689
Posts |
I have 2ca9 but am not running any dp fix trying to get rid of the dreaded 2c31 code.
__________________
Legal Disclaimer: Anything I or anyone else says about my vehicle on this website(1addicts.com or any affiliated or nonaffiliated sites), pertaining to modifications, is only to gain acceptance from my/our peers, and does not actually represent anything actually existing on my car, and thus, cannot be held against me in any issues, i.e. warranty claims, that may arise.
|
Appreciate
0
|
02-18-2010, 10:39 PM | #5 |
Private First Class
6
Rep 198
Posts |
Well 19 & 20 are both yellow and 23 is the only black/red on that side ... I'll have to pull it tomorrow and double check but I went over it many times before I installed it
__________________
Not Stock... |
Appreciate
0
|
02-18-2010, 10:50 PM | #6 |
First Lieutenant
18
Rep 328
Posts |
I am looking to install mine, haven't done so yet but would be great, since your working on it to take some pictures, or even create a diy.
|
Appreciate
0
|
02-18-2010, 10:55 PM | #7 |
Lieutenant Colonel
116
Rep 1,971
Posts
Drives: 2009 e92 MR "Civic" ///M3
Join Date: Feb 2009
Location: Miami, FL
|
I got the same exact codes when I first installed the DP fix a while back... I tripple checked everything, and I had the wires in the correct pins.. but I flipped 19 and 20 or something like that when putting them back in the harness.. may be worth a look.. don't remember the exact number of the pins.. but they were crossed in the harness not at the DP wires..
__________________
|| DCT | ESS Tune | ACM Test-pipes | AA Green Filter | Swift Spec-R Springs | Stoptech ST-40 F || || My Youtube Channel ||
|
Appreciate
0
|
02-18-2010, 11:06 PM | #8 | ||
Private First Class
6
Rep 198
Posts |
Quote:
Quote:
..................... So ... upon reading the instructions again (I've already read them a couple times) I think I may be an idiot ... I skipped over the part about plugging the male ends of the DP Fix into the stock wires, I just unplugged the 19,20 & 23 and tapped them off So it looks like I fail ... I need to learn to read ... Thank you all for you help EDIT TO ADD: Wanted to give a big Thank You to Terry for helping me with this ... he was very prompt with his responses and is a stand-up guy
__________________
Not Stock... Last edited by MeinBMW; 02-18-2010 at 11:54 PM.. |
||
Appreciate
0
|
02-19-2010, 11:43 AM | #9 | |
Lieutenant Colonel
116
Rep 1,971
Posts
Drives: 2009 e92 MR "Civic" ///M3
Join Date: Feb 2009
Location: Miami, FL
|
Quote:
__________________
|| DCT | ESS Tune | ACM Test-pipes | AA Green Filter | Swift Spec-R Springs | Stoptech ST-40 F || || My Youtube Channel ||
|
|
Appreciate
0
|
02-19-2010, 12:13 PM | #11 |
452
Rep 18,331
Posts |
|
Appreciate
0
|
02-19-2010, 02:22 PM | #12 | |
Private First Class
6
Rep 198
Posts |
Quote:
the first thing I did was email Terry and he replied very promptly, I only posted here because he wasn't sure what the cause could be so I posted here to see if anyone else had had this issue .. Overall Terry was great and I really appreciated his quick replies .. You usually don't find service like that nowadays
__________________
Not Stock... |
|
Appreciate
0
|
02-19-2010, 06:10 PM | #13 | |
Joint Chiefs of Staff
4980
Rep 116,110
Posts |
Quote:
Mike |
|
Appreciate
0
|
04-26-2021, 01:17 PM | #14 | |
Z4 35is
65
Rep 270
Posts |
Quote:
I've done multiple drive cycles each time clearing codes. Cat monitors just dont complete. Its stuck in "Incomplete". I double checked the cables, it looks fine. What could i be doing wrong?
__________________
2011 Z4 E89 35is 2016 435i GC m-sport
|
|
Appreciate
0
|
Bookmarks |
Thread Tools | Search this Thread |
|
|