[Stoatmaster]

Morning,

Ran BMWhatApp yesterday to clear down the code for a blown bulb which I had replaced. When I pulled the code, I was presented with the following, despite there being no engine management or warning lights;

Motor Control:
Engine / Motor
Fault: :throttle 2 / Pedal sensor plausibility / Throttle potentiometer 2 / Air mass meter, signal correction
Code: 2B07
Fault: :Throttle potentiometer 2 / throttle 2 / Pedal value sensor 2 / Accelerator pedal module , pedal sensor 2 / Air mass meter, signal correction
Code: 2B06
Fault: :Intake manifold pressure / Intake air temperature sensor bank 1
Code: 2AFB
Fault: :Nitrogen oxide sensor
Code: 30DA

Car is running quite happily, and I'm sure these codes were not there a month ago when I ran an initial scan. (Shame it doesn't date them to any degree)

Any thoughts?

[Aragorn30d]

INPA will tell you the mileage figure of when the fault appeared.

Or you can clear them and see if they return.