|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
XDrive transfer case mount replacement without special tools
|
|
06-17-2022, 09:22 AM | #1 |
Private First Class
93
Rep 150
Posts |
1. remove TC bracket and exhaust support
2. Put two short bracket bolts into gearbox side of TC. Use big through bolt nut to space the top bolt as pictured, it will turn in like 1 thread. Bolts are now same height. 3. Put through bolt back in mount and use it to mark position of the hole to drill in 2x4 wood 4. Pry out old bushing with hammer and chisel once half way turn chisel 90 and keep going. Hammer/chisel from gear box end did nothing but scratch the bore 5. Use fine sand paper to clean bore smooth 6. Freeze mount the night before to shrink (maybe optional) use dish soap to press mount in 1cm by hand. Make sure it's aligned. 7. Use wood, oil filter tool and threaded rod with nuts to wind in new mount. Don't worry if the rubber distorts a little bit under oil filter tool. |
04-27-2023, 11:17 AM | #3 | |
Enlisted Member
4
Rep 37
Posts |
Quote:
I went to install the new one, was giving me an issue so I threw it in the freezer an hour ago. Bro, I am so happy I found your post. God damn genius and so simple. Thank you in advanced for saving me from a headache |
|
Appreciate
0
|
Bookmarks |
Thread Tools | Search this Thread |
|
|