[benjaminstrid04]

Hey! I understand the DSC is pretty problematic on these cars. Now mine has failed. Went and bought a second hand unit, talked to schmiedmann about it and they assured me that it would fit. I swapped only the hydraulic block since I did not want to code in a new module. Bought a power bleeder to make sure the bleeding process was done thoroughly. The problem is that ISTA/D still does not want to perform the DSC sensor calibration. I have checked powers and grounds to the DSC unit and they seemed fine. Also did the bleeding procedure through ISTA if that makes any differans.

I have the module too from the donor vehicle but I don’t know how I would code it to my own car. Maybe that is the next step? If so I would be glad for all the help I can get!

Code is 5E20

//Benjamin