|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
New JBE module installed IFH-003: Error on INPA
|
|
06-14-2018, 03:52 PM | #1 |
Enlisted Member
10
Rep 46
Posts |
New JBE module installed IFH-003: Error on INPA
Hi,
I had a JBE module replaced with the original one. Most of the electronics are working (except it shows error on airbags/seatbelts) and the left mirror wont fold upon reverse. I am trying to read errors with INPA but it gives me: IFH-0003: DATATRASMISSION TO INTERFACE DISTURBER. View post on imgur.com What could be the reason for diagnostic software not communicating with the car? The setup of my machine and INPA is definitely good. It does show when ignition is on or off but that is it. Thanks for any advice. |
06-03-2021, 06:10 AM | #4 | |
Registered
0
Rep 3
Posts |
Quote:
In my case I think it's because my car uses K-can & the newer JBE is D-can? Anyone know how this can be resolved? Old (damaged) JBE: PL2 JBBFE , H4 New (used) JBE: PL2 JBBFE 2, H4 But I cannot connect to INPA, returns a 'IFH-0003: DATATRASMISSION TO INTERFACE DISTURBER' fault. Last edited by E912006; 06-04-2021 at 02:40 AM.. |
|
Appreciate
0
|
06-04-2021, 02:00 PM | #5 | |
Lieutenant Colonel
654
Rep 1,893
Posts |
Quote:
I think ICON2015 commented on this so search for posts by him |
|
Appreciate
0
|
Bookmarks |
|
|