|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Problem with passenger window
|
|
02-22-2020, 09:35 AM | #1 |
Private
0
Rep 60
Posts |
Problem with passenger window
Guys I have e90 , 320D , 163hp, 2005y.
I replaced the FRM 2 module. After the change, I coded the car, everything worked except the passenger window. Everything was fine with the old module. I put the same TRC file in new FRM 2 but the passenger window when lifted up in automatic mode it opens about 30mm and stays open. Please if anyone knows how to fix it let me help. I am attaching a video of this issue, and show mine TRC file. https://youtu.be/yXcsvvEId6U |
02-22-2020, 02:57 PM | #2 | |
Captain
182
Rep 780
Posts |
Quote:
|
|
Appreciate
0
|
02-22-2020, 03:12 PM | #3 |
Brigadier General
2683
Rep 4,025
Posts |
Initialize Power Windows; NO Software Required
You can "Initialize" Power Windows (one at a time) WITHOUT any special Software per Bentley as follows:
B. Bentley 512-19 & 20; 692 & 693 pdf: First: Erase or Delete Previous Initialization Second: perform NEW Initialization Procedure INITIALIZING WINDOWS, Bentley 512-19 & 20; 692 & 693 pdf Two parameters are learned during initialization: • Upper end stop (normalization of the power windows). • Power characteristic curve for opening and closing (learning the characteristic curve). The initialization can be carried out using the control switch in each door or the power-window switch block in the driver's door. The following requirements are necessary for initialization to be carried: • Vehicle stationary. • Adequate battery voltage present (12.4 volts), connect vehicle power supply if necessary. • Terminal R (radio readiness) or terminal 15 switched ON (ignition ON) See 020 Maintenance for vehicle key states. • All doors closed. Deleting a previous initialization Deleting an initialization and subsequent re-initialization can remedy sporadic, incorrect shutdowns in one touch operation mode. Open the window of each door completely. Press and hold the control switch completely (switch position: one touch operation mode) for longer than 15 seconds and less than 20 seconds. Deletion of the initialization was successful when one touch operation mode is no longer possible for window close function. Performing initialization - Fully close window by pulling the switch so that the top end stop is reached (normalization). - Open the window completely so that the lower end stop is reached. - Pull the control switch into one touch operation mode, close (one touch operation, close) position and hold it there until the window has reached the top end stop (learning the characteristic curve). The initialization was successful if the window can be opened and closed without faults in one touch operation mode. NOTE- • Windows will move in small increments if not initialized George |
Appreciate
0
|
02-22-2020, 06:11 PM | #4 |
Private
0
Rep 60
Posts |
|
Appreciate
0
|
02-22-2020, 10:07 PM | #5 | |
Captain
182
Rep 780
Posts |
Quote:
It may not be 100% like above but it should be close enough for you to figure out |
|
Appreciate
0
|
Bookmarks |
|
|