[fredtr]

I tried to use INPA to calibrate XI transfer case, when I attempt it in INPA it displays "Not Supported By This SW-Version" I'm using INPA loader VGSG 1.000 INPA 5.0.6 Top Gear Solutions 5/19/2018, so I am assuming I need to upgrade my software, INPA, NCS etc., can someone point me to where I can find it? Thank-you.

[m_fife]

Originally Posted by fredtr

I tried to use INPA to calibrate XI transfer case, when I attempt it in INPA it displays "Not Supported By This SW-Version" I'm using INPA loader VGSG 1.000 INPA 5.0.6 Top Gear Solutions 5/19/2018, so I am assuming I need to upgrade my software, INPA, NCS etc., can someone point me to where I can find it? Thank-you.

Try a copy of ISTA-P

[ctuna]

It would be ista D for the calibration procedure for the transfer case.
Ista D should work . Use the bimmergeeks version of standard tools
it's known to work people seem to always have trouble with some standalones.

You didn't say the year of your car I believe.
If you are not in the E series range of dates that could be a problem.
F and beyond use E sys which is an ethernet based system.