|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
2011 E90 335d ETM? Need pinout and color codes OBD2
|
|
10-02-2022, 09:49 AM | #1 |
Enlisted Member
2
Rep 36
Posts |
2011 E90 335d ETM? Need pinout and color codes OBD2
I need a ETM for a 2011 E90 335d.
Needed to replace the OBD2 plug. The little tabs that are used to attache to the car broke. I wrote everything down when I started this but I got distracted for about 6 months and I cannot find my notes about what color wire goes to what pin. I have a pig tail out of another e90 courtesy of Strictly German in Braselton, GA. Nice people. Unfortunately, the wire color are different so I'm still at square one. I can find pin-outs all over the place. The wire color is a different thing.
__________________
--------------
Mi aerodeslizador está lleno de anguilas. 2011 E90 335d Solo Motorsports custom tune |
10-02-2022, 10:06 AM | #2 |
Brigadier General
765
Rep 3,556
Posts |
Are the pins removable on the OBD port? If yes, had you considered depinning your German one and 1 by one move the wire w/pin into German OBD connector? Lots of work either way interms of connecting the different color wires together (with your requested chart) or just move the pins over one at a time. I'm here to learn about this connector. Thanks
|
Appreciate
0
|
10-02-2022, 11:12 AM | #3 |
Enlisted Member
2
Rep 36
Posts |
tried de-pinning. Bought the tool. No joy. Some of them just refused to come out. At this point the damage is down. I think I found something on ebay. PDF wiring manual.
https://www.ebay.com/itm/11511325167...&segname=11050
__________________
--------------
Mi aerodeslizador está lleno de anguilas. 2011 E90 335d Solo Motorsports custom tune |
Appreciate
0
|
10-02-2022, 11:35 AM | #4 |
Enlisted Member
2
Rep 36
Posts |
problem solved.
With pin out and a new OBD2 pigtail from amazon. https://www.amazon.com/iKKEGOL-Unive...%3D%3D&sr=8-30
__________________
--------------
Mi aerodeslizador está lleno de anguilas. 2011 E90 335d Solo Motorsports custom tune |
Appreciate
0
|
10-02-2022, 02:23 PM | #5 | |
Brigadier General
765
Rep 3,556
Posts |
Quote:
I hadn't ever dug into the OBD connector. From your Amazon link, they look to be receptacles rather than pins. The little shark tooth anchor should be the same and only difference is female vs male. I'll try to find the receptacle specs for the OBD. I have an intermittant thing where my Foxwell scanner reads sometimes and not others. If I run power from home to the micro-mini port of Foxwell, it always works. I think i have a receptacle that is pushed in a little bit where it doesn't make good contact with Foxwell's pin. I'm betting it is the connection for scanner's power. |
|
Appreciate
0
|
10-03-2022, 09:37 AM | #6 |
Enlisted Member
2
Rep 36
Posts |
yes. it's the whole plug. i'm just going to solder the wires and be done with it.
__________________
--------------
Mi aerodeslizador está lleno de anguilas. 2011 E90 335d Solo Motorsports custom tune |
Appreciate
0
|
Bookmarks |
Tags |
electircal, obd2 |
|
|