[colinjw7]

Hey guys... just wanted some input on this. I've noticed that it looks like there's oil in these spots under the plastic engine cover. I suspect it could be a bad valve cover gasket. Here's a picture.... let me know what ya think... thanks

[colinjw7]

Also if it is, what would be good to check out/ replace while down there.

[Chappers 71]

If the vc is leaking you'll see oil along the top of the heat sheild. Oil under the plastic covers most likely from oil spillage whilst putting in oil.
If the gaskets haven't previously been replaced it's likely that all of them will need replacing on a 2007

[Bimmer_Bro]

Originally Posted by Chappers 71

If the vc is leaking you'll see oil along the top of the heat sheild. Oil under the plastic covers most likely from oil spillage whilst putting in oil.
If the gaskets haven't previously been replaced it's likely that all of them will need replacing on a 2007

Your oil cap is seeping and drooling down into that area. Clean the cap and the rubber seal good. Also clean where it connects. This usually stops it for a while. Or you can get a new cap.
Like states above it could also just be old overspill .

[colinjw7]

Originally Posted by Bimmer_Bro

Your oil cap is seeping and drooling down into that area. Clean the cap and the rubber seal good. Also clean where it connects. This usually stops it for a while. Or you can get a new cap.
Like states above it could also just be old overspill .

Ok thanks! I'll take a closer look and give cleaning a he cap a try!