[WesMul]

Hi everyone, first post after a lot of reading.

Today I retrofitted a new(second hand) SZL with Cruise Control lever on my 2007 E92 325i.

After doing the physical install in less than an hour I started on the coding side of the job.

First I changed the VO and added $544 with NCS expert en than I used FA_WRITE to change de VO in my CAS en FRM module. Second I used SG_CODIEREN to my KOMBI, CAS, FRM and DSC ECU.

After this, I started the car and it throws a DSC, Active steering and tire pressure error and handbrake error.

I tried to solve this by using ISTA-D and recalibrating the DSC afterward followed by the calibration of the active steering. But it keeps failing the active steering calibration at the point where you need to keep turning the steering wheel 10 degrees left and right.

I also tried to reset it using tool32. But when I click lenkwinkkel_dsc_ableichen. afterward job status is OKAY but it doesn't seem to do anything.

I hope some of you guys have some ideas about what it could be?

[sdbmwcoding]

What are the faults in Ista?

[WesMul]

The Fault codes are 005E43 DCS: Steering angle sensor: Adjustment
00614A AL: Motor position angle: not initialized
0094B5 DCS: Steering column switching centre: internal fault
00CE93 Message (Steering wheel angle, 0xC8) faulty, receiver active steering, transmitter...

[Diawal91]

Originally Posted by WesMul

The Fault codes are 005E43 DCS: Steering angle sensor: Adjustment
00614A AL: Motor position angle: not initialized
0094B5 DCS: Steering column switching centre: internal fault
00CE93 Message (Steering wheel angle, 0xC8) faulty, receiver active steering, transmitter...

+1