|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
DP Fix for sale
|
|
01-20-2021, 08:37 PM | #331 | |
Registered
2
Rep 3
Posts |
Quote:
Thank you. I had it at the 5 o'clock position, but was throwing 29F4 and 29F5. I increased the strength, but also realized I did not reselect the oem/catted DP option in MHD when I flashed back to stage 0. After reflashing the car and with the dial at ~8 o'clock I am currently throwing 29E0 and 29E1. Should I go back to 5 o'clock and give it another try? |
|
Appreciate
1
darrien21430.00 |
01-21-2021, 06:04 AM | #332 | ||
Aw sh!t
111
Rep 988
Posts |
Quote:
__________________
Bigger is always better! M4
|
||
Appreciate
0
|
01-23-2021, 06:51 PM | #333 |
Registered
2
Rep 3
Posts |
Got it to work. Went back to the 5 o'clock position and was still throwing 29F4 and 29F5. Adjusted it to 7 o'clock and same result. It finally completed the catalyst check at ~8:30. Thanks for the help.
|
Appreciate
0
|
01-23-2021, 07:56 PM | #334 |
Aw sh!t
111
Rep 988
Posts |
Good to here
__________________
Bigger is always better! M4
|
Appreciate
0
|
01-29-2021, 02:17 PM | #335 |
New Member
0
Rep 7
Posts |
Can't get Evap to set ready
I have a 2012 335is with catless DPs. I'm running MHD and was running stage 2+. I had no codes so went to get emissions checked and got "not ready for Cats and O2 sensor. I purchased your DPfix and installed it last eve. and flashed back to Stage 0. Went out and drove it for a "drive cycle" and got Catalyst to set right away, but still have O2 sensor not ready and now Evap not ready. Evap was ready before. I went out and drove it more this morning and went about 50 miles. Tried to follow the drive cycles posted online.. for the most part. Drove down residential streets, divided highways, expressways, etc. but can't get O2 or Evap to set ready. The emissions here allow 1 not ready, so I really just need the Evap to set again like it was before. Any ideas why the O2 sensor is showing not ready? And more importantly why the Evap is not setting. Will it not reset if the O2 sensor isn't reset? No DME codes in MHD "check codes". I even stopped by a local repair shop and had them check with their scanner.. same 2 not ready. He did find a code A6CF which is for AUC sensor but that seems to be the sensor that controls the recirculation for the A/C. It was not a main DME fault code. HELP!
Last edited by az335rider; 01-29-2021 at 06:47 PM.. |
Appreciate
0
|
01-30-2021, 12:53 PM | #336 | |
Aw sh!t
111
Rep 988
Posts |
Quote:
__________________
Bigger is always better! M4
|
|
Appreciate
0
|
01-30-2021, 07:16 PM | #339 | |
New Member
0
Rep 7
Posts |
EVAP
Quote:
|
|
Appreciate
0
|
01-31-2021, 03:01 AM | #340 | ||
Aw sh!t
111
Rep 988
Posts |
Quote:
1. Clear adaptions and try the drive cycle again 2. Adjust the dial clockwise 1/8 of a turn and perform the drive cycle. If you start to get a code then you dial it back. For the most part both should show up as ready but sometimes it does take a little longer unless you have a fouled sensor. This could be checked by moving the black male pin from position 19 to position 20. Position 20 is the other post o2 sensor. Hope this helps. Let me know how it goes.
__________________
Bigger is always better! M4
|
||
Appreciate
0
|
02-05-2021, 02:51 AM | #342 |
Boost
1353
Rep 3,691
Posts
Drives: 135i M-Sport
Join Date: Feb 2014
Location: Valley of Silicon, CA - United States
|
Do you have an install guide? I picked up one of these secondhand and need to get the track car snogged ASAP.
Thanks!
__________________
F80 M3 TrackBoi, Z4MC GarageBoi, 1M Clone StreetBoi
|
Appreciate
0
|
02-05-2021, 04:56 AM | #343 | |
Aw sh!t
111
Rep 988
Posts |
Quote:
Hope this helps. I use blue cables in place of the red ones
__________________
Bigger is always better! M4
|
|
Appreciate
0
|
02-06-2021, 01:35 AM | #344 | |
New Member
0
Rep 7
Posts |
IT WORKED!
Quote:
|
|
Appreciate
0
|
02-06-2021, 11:37 PM | #345 | ||
Boost
1353
Rep 3,691
Posts
Drives: 135i M-Sport
Join Date: Feb 2014
Location: Valley of Silicon, CA - United States
|
Quote:
__________________
F80 M3 TrackBoi, Z4MC GarageBoi, 1M Clone StreetBoi
|
||
Appreciate
0
|
Bookmarks |
Thread Tools | Search this Thread |
|
|