|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
E90 330D - Rear Toe Adjustment
|
|
01-13-2018, 11:25 AM | #1 |
Captain
129
Rep 828
Posts |
E90 330D - Rear Toe Adjustment
Hi All,
After hitting a kurb in the snow and looking at all of the arms (which appear fine) I wanted to try and adjust the toe in just so it's driveable but twisting the bolt is seriously hard and doesn't seem normal and now the bolt is very slightly rounding off. I was just wondering if maybe the hub needs to be raised to relieve tension on the arm or something? Just to clarify I've already loosened the nut. Cheers. |
01-13-2018, 05:43 PM | #2 |
Brigadier General
448
Rep 3,312
Posts |
Shouldn’t generally need to relieve any tension as when doing alignment it would be under the same. It sounds like it may well be bent or something when the knock took place.
It may be worth lifting it and trying to get the bolt out a little to check it.
__________________
E92 335i / M3 Hybrid - The Build
|
Appreciate
0
|
01-13-2018, 06:03 PM | #3 | |
Captain
129
Rep 828
Posts |
Quote:
Took about 35 minutes to remove the strut then £40 for the spring and £20 to have the spring installed. But my gosh.. getting the strut back on was a different story, despite removing the control arms and steering rack (tie rod or track rod I believe) I could never get the clearance so the top of the strut could fit into the arch! I ended up removing the calliper, all three arms, abs sensor and I was sitting with the hub completely removed from the car.. have to admit I was wondering if I was going to get it back together but a few hours in all was back! So back to square 1.. I popped to a garage up the road to see if they could squeeze me in for tracking but he couldn't track rear wheel or something.. he also said if it's an E90 not to waste my time on anything and replace the subframe. Though I can't see it being the subframe.. I can't see how the camber arm can be perfectly fine (I completely removed it and compared to another camber arm from the garage up the road) and also the camber arm bushing on the subframe is still fine but the subframe experience the damage.. I just can't see it being possible in my head, the initial impact should cripple the weak spots on the arms first. Time will tell but I'm not sure how long I'll have to wait until I can get it in again :/ |
|
Appreciate
0
|
01-15-2018, 07:56 AM | #4 |
Brigadier General
448
Rep 3,312
Posts |
Although all the arms may appear to be fine they could well not be and also you have to remember that when the hit happens it's the weakest points that buckle first. If the toe arm joint is the weakest point in that contact then that will be the bit that bends slightly to absorb the energy etc.
__________________
E92 335i / M3 Hybrid - The Build
|
Appreciate
0
|
01-15-2018, 10:06 AM | #5 | |
Captain
129
Rep 828
Posts |
Quote:
|
|
Appreciate
0
|
01-16-2018, 03:37 AM | #6 | |
Brigadier General
448
Rep 3,312
Posts |
Quote:
__________________
E92 335i / M3 Hybrid - The Build
|
|
Appreciate
0
|
01-16-2018, 07:47 AM | #7 |
Captain
129
Rep 828
Posts |
Cheers mate, it was surreal to be back on the road after so long haha. Have to say, with looking into renewing the arms I couldn't help but stumble upon people sticking M3 parts on and saying how much better the car feels.. really thinking of going down that route!
|
Appreciate
0
|
Bookmarks |
|
|