[DELTA33]

So against my better judgement I went ahead after putting it off waiting for DP's to come in to try and install the Jb4 myself. I followed the instruction, felt good about the seating and every time I try and start the car I get the yellow light and service engine soon, When I hit the gas there is absolutely no response.

I have emailed Terry but I know it is Sunday and probably wont get looked at til tomorrow when I need to be at work lol

I'd like to try and get this thing right without having to go back to stock set up.

Any help would be greatly appreciated.

[caliguy562]

Power wire on JB connected?

[melenkae90]

I'd double check to make sure none of the pins are bent, and make sure none of the clips were put in backwards to start with.

[Beemw335]

Its simple, theres 4 subconnectors and 1 power wire.
Make sure all subconnectors go in with the arrows pointing inwards and that theyre in the right slot obviously...power wire you need to hear it click when you put it in...other than that only other tricky part is the large connector, to put it back youll need to lift up the ecu just a bit so it can go in properly. If you did all that right, the jb4 is defective/bad firmware.

[DELTA33]

Ok So Terry is alive and well servicing his very frustrated clients on a Sunday. All I have to say is this guy ROCKS!

He walked me thru my issues, which were all mine BTW and now all we have to do is delete some codes...which I am in the process of learning lol. Anyone have a link?

[DELTA33]

found it :-)

http://www.n54tech.com/forums/showpo...98&postcount=1