[CashedUpBogan]

Originally Posted by donR

Yep I just checked and one set is yours, all paid up. Welcome to pick up from Willoughby or can post.

Sweet. I'll drive up once I get my car back in February 2019

[EB89]

Originally Posted by donR

Yeah, just doing final testing on the interior kits now. A few different options. I'll let you know at the end of the week.

Oh sweet as!

[EB89]

Originally Posted by bradsm87

Does the Carly app have a trailer light voltage monitoring disable option?

Trailer? Didn't know our cars even had the trailer cable plug.

You are best to look here, somewhere on there you can go through the codding possibilities for each car.

http://support.mycarly.com/

[bradsm87]

Originally Posted by EB89

Trailer? Didn't know our cars even had the trailer cable plug.

You are best to look here, somewhere on there you can go through the codding possibilities for each car.

http://support.mycarly.com/

Cheers. I'll check it out. As soon as a CAN bus trailer module is fitted to the car, the trailer lights are monitored and LED trailer lights make it throw constant errors. I've fitted resistors to my trailer lights but not quite low enough resistance so every now and then, I'll still get an error. From memory, one of the modules have an option "LED trailer lights fitted" but I can't remember where and haven't used NCSExpert for ages.

[p1zaul]

Are these lci led bulbs option 3 still available?

[Socket]

Originally Posted by p1zaul

Are these lci led bulbs option 3 still available?

this thread is from 2016... pretty sure Don has sold up and moved on

[donR]

Originally Posted by p1zaul

Are these lci led bulbs option 3 still available?

Yep, I've moved on but still occassionally drop in. I think I might have one left but you'd probably be able to get one in your local area but let me know if you want me to check. I know I had a bunch of things left over that are just sitting around.

[p1zaul]

I guess I'm still a bit confused as the bulb itself seems to be permanently attached to this board. It seems like the whole board needs to be replaced if one of the bulbs go out.

This is the part

https://www.ecstuning.com/b-genuine-...hoC-XkQAvD_BwE

[shannon1]

The bulbs should just be push in and turn to remove and replace. If the ones in the the pic above are stuck, there appears to be some discolouration around the base of the bulbs which could have been caused by a short and melting plastic.

[R3dLeader]

On E93 the reverse bulbs are soldered to the board.

On E92 the bulbs pull out.

[shannon1]

Originally Posted by R3dLeader

On E93 the reverse bulbs are soldered to the board.

On E92 the bulbs pull out.

Ahh damn, that sucks. Well you learn something new everyday.

[Greger]

nice will make upgrade.