TNT Racewerks
BMW 3-Series (E90 E92) Forum > E90 / E92 / E93 3-series Technical Forums > DIY Guides > e9x Cargo Net Upgrade

Thread Tools Search this Thread
      01-18-2015, 03:09 PM   #1
New Member

Drives: e92 lci 320d M Sport
Join Date: Jan 2015
Location: Plymouth, UK

iTrader: (0)

e9x Cargo Net Upgrade

Parts needed, 25mm hole saw for hand drill, and 6 x clips (2 parts to each, part number in pic)

On reverse off boot/trunk floor cover are six circle indentations. You need to drill these with the hole saw.

Then you should have a hole like this, if you look at the insert you can see it has a tab that needs a cut out, to stop it rotating, i used a 4mm drill bit.

note. clips are at differnt angles, the notches all point towards the middle

Insert the clip

Flip it over and fit second half of clip, push it on then give it a hard tap and it should snap up tight.

Repeat on rest of the five holes

When all done should end up with this

Borrowed pic until i pick up my net


Last edited by m_attt; 01-18-2015 at 03:16 PM.
Appreciate 0


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -4. The time now is 03:17 PM.

Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST