[Mingwan]

Ok, so im in the middle of installing the flex fuel wires and Im at the part where you're supposed to put the flex fuel wire into the AMP connector. I found two discrepancies with the instructions.

1) It states that of the two wires, one is exposed due to the insulator being cut away. When i received my flex fuel wires, i found that both had their insulators cut away. I figured out that the longer of the two wires is the one that goes into the AMP.

2) It states that there is a wire with a gold pin....neither have a gold pin... this is the part i am stuck at.

How am i supposed to put the flex fuel wire into the AMP connector without a gold pin? is it safe by just twisting the wire and jamming the wire into the connector? im assuming not...

[SRT14PimPin07]

Sounds defective, send it back