[snipersix]

has anyone done this yet? I'm looking for some installation pictures can't seem to find any.

basically I'm looking to get a eisemann race quad for my 328i, but I want it to look like the quad setup for the 335. Similar to this:



Any help would do thanks

[SV Concepts III]

This is what you would need which routes the piping across to the passenger side.

[MMAJNKE]

I have done it but not with eisenmann exhaust setup it would space it out differently then a 335i setup. I'm going to be parting out my car soon so I will prolly let it go

[snipersix]

Originally Posted by Nick@Jlevi SW

This is what you would need which routes the piping across to the passenger side.

I already have this on order. What I'm concerned is the installation part.

[snipersix]

anyone?

[MOTO69JOE]

You're going to need a 335 trunk floor and you'll need to fabricate brackets for the black can that has fuel lines running into it.

[snipersix]

Originally Posted by MOTO69JOE

You're going to need a 335 trunk floor and you'll need to fabricate brackets for the black can that has fuel lines running into it.

hmm sounds like alot of work. Thanks for the input. Im going to drop by a shop and see what they can do

[SV Concepts III]

If you have the non-335 system on order, then the install will be like any standard muffler replacement. You will need to cut off the factory muffler and weld or clamp on the new system.

[ah gon]

if u already ordered the eisenmann quad exhaust.then u can't do any thing about it!
y u dont get the manaflow with 2 out,so u cant weld the extend pipe to make 335i style.
8kline did that and look nice!

[MOTO69JOE]

the trunk insert replacement is a simple DIY. Depending on your mechanical ability fabricating the two hanging brackets for the black cylinder can be a easy DIY as well.

[SGxi]

The spacing for the Eisenmann is further apart than the 335 quad setup, you will need a good muffler shop to do the mod so it is more centered.

Eisenmann setup with pic:
http://www.e90post.com/forums/showthread.php?t=23124

Someone over here in Toronto did a dual out conversion with the stock muffler. The routing for the pipes were pretty clever. I don't have a pic of the undercarriage, but this is do able. Only thing that needs to be cut is part of the undercarriage trim cover and your OEM muffler. Cyba tips will work since they are shorter in length compare to dimisa. Some members used the magnaflow tips, and they appear to have a large selection of them in various length.

As long as you have the quad diffuser for a good muffler shop to use as a template on how you want the tips to come out, they should be able to reroute to make it work, but they will be cutting up your brand new eisenmann setup.

As for the 335i storage bin, you don't really need it, unless the muffler is placed horizontally across the undercarriage rather than a straight setup:

Straight setup with pic (Koreez88's setup)
http://www.e90post.com/forums/showthread.php?t=371289
Also (headlee103's setup):
http://www.e90post.com/forums/showthread.php?t=379188
Also (sorost's setupt):
http://www.e90post.com/forums/showthread.php?t=369869

Horizontal setup with pic (Vicnumb7's setup)
http://www.e90post.com/forums/showthread.php?t=239140

If you want a centered look straight out of the box, you should buy the Hamann quad setup (chng_fei's car)
http://www.e90post.com/forums/showthread.php?t=110772

Otherwise, since Supersprint makes the Hamann quad, you can consider modding a supersprint exhaust (posted by Dimsum, setup belongs to another member in E90post)
http://www.e90post.com/forums/showthread.php?t=371712

Hope this helps...

Also check this thread, there are quite a few photos of the Eisenmann setup.
http://www.e90post.com/forums/showthread.php?t=45158

Some people had to relocate the canister since the tips they have are too long, and solution is in this thread:
http://www.e90post.com/forums/showthread.php?t=371258

***With the eisenmann setup, you should not need to relocate the canister or replace your 328 trunk bin to a 335 one.*** What your muffler shop needs to do is relocate the tips coming out of your muffler and shorten the length of the extension on the other side.

[bavarian19]

Mods, please sticky this thread.

[snipersix]

Originally Posted by SGxi

The spacing for the Eisenmann is further apart than the 335 quad setup, you will need a good muffler shop to do the mod so it is more centered.

Eisenmann setup with pic:
http://www.e90post.com/forums/showthread.php?t=23124

Someone over here in Toronto did a dual out conversion with the stock muffler. The routing for the pipes were pretty clever. I don't have a pic of the undercarriage, but this is do able. Only thing that needs to be cut is part of the undercarriage trim cover and your OEM muffler. Cyba tips will work since they are shorter in length compare to dimisa. Some members used the magnaflow tips, and they appear to have a large selection of them in various length.

As long as you have the quad diffuser for a good muffler shop to use as a template on how you want the tips to come out, they should be able to reroute to make it work, but they will be cutting up your brand new eisenmann setup.

As for the 335i storage bin, you don't really need it, unless the muffler is placed horizontally across the undercarriage rather than a straight setup:

Straight setup with pic (Koreez88's setup)
http://www.e90post.com/forums/showthread.php?t=371289
Also (headlee103's setup):
http://www.e90post.com/forums/showthread.php?t=379188
Also (sorost's setupt):
http://www.e90post.com/forums/showthread.php?t=369869

Horizontal setup with pic (Vicnumb7's setup)
http://www.e90post.com/forums/showthread.php?t=239140

If you want a centered look straight out of the box, you should buy the Hamann quad setup (chng_fei's car)
http://www.e90post.com/forums/showthread.php?t=110772

Otherwise, since Supersprint makes the Hamann quad, you can consider modding a supersprint exhaust (posted by Dimsum, setup belongs to another member in E90post)
http://www.e90post.com/forums/showthread.php?t=371712

Hope this helps...

Also check this thread, there are quite a few photos of the Eisenmann setup.
http://www.e90post.com/forums/showthread.php?t=45158

Some people had to relocate the canister since the tips they have are too long, and solution is in this thread:
http://www.e90post.com/forums/showthread.php?t=371258

***With the eisenmann setup, you should not need to relocate the canister or replace your 328 trunk bin to a 335 one.*** What your muffler shop needs to do is relocate the tips coming out of your muffler and shorten the length of the extension on the other side.

thanks for the help. I will keep this in mind.