|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
02 sensor brand?
|
|
03-10-2022, 11:28 AM | #1 |
Lieutenant
210
Rep 498
Posts |
02 sensor brand?
Bosch vs ntk? I need to get all 4 02's the Bosch are only $20-30 more per 02 so I don't mind but I've read ntk are better. I'm gonna be wrapping my manifold but their is the extra heat of a top mount
|
03-10-2022, 01:53 PM | #2 |
Second Lieutenant
110
Rep 257
Posts |
|
Appreciate
0
|
03-10-2022, 02:29 PM | #3 | |
Lieutenant
210
Rep 498
Posts |
Quote:
|
|
Appreciate
0
|
03-11-2022, 10:09 AM | #4 | ||
Second Lieutenant
110
Rep 257
Posts |
Quote:
|
||
Appreciate
0
|
03-11-2022, 10:31 PM | #5 | |||
Lieutenant
210
Rep 498
Posts |
Quote:
|
|||
Appreciate
0
|
03-12-2022, 07:39 AM | #6 | ||||
Second Lieutenant
110
Rep 257
Posts |
Quote:
|
||||
Appreciate
0
|
09-08-2023, 09:37 AM | #7 |
Lieutenant Colonel
3335
Rep 1,913
Posts |
sorry to bump this, but you put the 2 front back to the cast speedtech manifold, and the 2 rear on the Y downpipe, where there's 2 bank close to each other ?
Question is , those 2 on the downpipe will essentially rear the same thing, is it preferable to cancel 1 to avoid bad reading or both are necessary to match the 2 front ? |
Appreciate
0
|
09-08-2023, 08:53 PM | #8 |
Lieutenant
210
Rep 498
Posts |
scrap the 02 bungs on the manifold I had some plugs laying around that I threw in. Car ate 3 sets of 02 sensors before mhd finally came out with single bank no issues since. drives much nicer, cleaner afr/trims and your not gonna be killing sensors left and right. Put 1 pre cat 02 in the bung of the downpipe. 1 post cat in the same stock location. Confirm which plugs they should connect to i believe it’s bank 1. Select single bank fueling when flashing mhd. Also ntk sucks ass or I just have the worst luck. I’ve stuck with oem bosche
|
Appreciate
1
oVeRdOsE.3334.50 |
09-09-2023, 06:51 AM | #9 |
Lieutenant Colonel
3335
Rep 1,913
Posts |
are you using solely MHD?
i'm on a back end map right now from jb4tech and getting my target boost pressure via the JB4. I was planning to use O2 extension of 90°, worked great in the past. |
Appreciate
0
|
Bookmarks |
|
|