Sponsored by The Tire Rack

[najericam]

So, I changed my old MV3's with MV4's, just one difference that new setup is Squared, all four are 8J ET37. Compared to old MV3's, outer rims side is more tucked in in front for 3mm (just offset difference) and rear 6.3mm (due 8J compared to 8.5). Shall I put any spacers and if yes, should 15mm at the back and 12mm in front do? This will bring me roughly 9mm out on each wheel compered to stock MV3's.

Also I was thinking of getting wider rears but it's very difficult to find them without cracks, which is a reason why I decided to go with square setup for now. Speaking of them, rear MV'4 compered to MV3's should pop out more for 4.4mm while front will be in for 3mm. I found this strange, to be more narrower in front and wider at the back compared to MV3's. Why at least front ones are not the same when they are bot 8J? Maybe silly question but in this case just 10mm at the back will bring me to ''factory'' outer position of the rims. :/

Anyway if anyone have idea about spacers, what is safe to do, I don't look for overkill here, just to bring it to ''normal''.

All tyres are 235/35/19 - so a bit wider than standard 225/35. Thanks.

Some pictures below: