|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
no Bluetooth after cic update
|
|
01-17-2019, 05:26 PM | #1 |
Private
8
Rep 83
Posts |
no Bluetooth after cic update
Hi all
So had my cic updated to lasted version. Required a wipe and reload as my firmware was very early cic. I had to reload fsc codes for all modules to get nav etc working as it should. I used fstool 32 for this. Since the upgrade of firmware, my 'telephone' option when chosen has just stayed on 'please wait' with a spinning icon and never loads, hence no Bluetooth. I have a 2008 320d e90. I'm comfortable coding and have a dcan cable and all relevant softwares but by no means and expert... I can follow guides just fine! Any ideas at all? I've checked fuse 17 which apparently runs this but there wasn't a fuse there. I've checked the module in the boot and it's bolted down and haven't had chance to remove and check connections. Just seems odd that since the firmware update, it's stopped. Thank you |
01-17-2019, 10:01 PM | #2 |
Lieutenant General
1911
Rep 13,101
Posts |
This is a question for the idrive and coding subforums.
Most likely the update wiped out the option setting that says there is a mulf or tcu . They would probably tell you to default code the CIC modules from the car VO. |
Appreciate
0
|
01-18-2019, 12:56 AM | #3 |
Private
8
Rep 83
Posts |
|
Appreciate
0
|
Bookmarks |
|
|