[N54_e90]

I was able to successfully update my transmission egs module following this thread:

http://www.bimmerfest.com/forums/sho.../621988?page=1

Daten files and winkfp installed via bimmergeeks.

After successfully updating i took the car for a quick spin and noticed an immediate improvement. No codes or anything.

Then i decided to reset all adaptions in inpa and i got a 2fa3 coding missing. Had a cel but it went away after a bit of driving.

I no longer have a cel but the code keeps coming back in inpa after clearing (again no cel illuminating). Car runs and drives great.

Any thoughts?

[Sensible_]

Originally Posted by crazythedon

I was able to successfully update my transmission egs module following this thread:

http://www.bimmerfest.com/forums/sho.../621988?page=1

Daten files and winkfp installed via bimmergeeks.

After successfully updating i took the car for a quick spin and noticed an immediate improvement. No codes or anything.

Then i decided to reset all adaptions in inpa and i got a 2fa3 coding missing. Had a cel but it went away after a bit of driving.

I no longer have a cel but the code keeps coming back in inpa after clearing (again no cel illuminating). Car runs and drives great.

Any thoughts?

Seems like it can happen:

http://www.1addicts.com/forums/showthread.php?t=1193909

Try key cycling. If not working run the test plan with ISTA and replicate with winkfp / NCS if required.

[N54_e90]

Originally Posted by Sensible_

Seems like it can happen:

http://www.1addicts.com/forums/showthread.php?t=1193909

Try key cycling. If not working run the test plan with ISTA and replicate with winkfp / NCS if required.

So clear fault, reset adaptation? Unplug key the plug back in with ignition on and check for fault? Should I do this in MSV80 or MSV70?

Thanks

[Levanime]

Default code it

[N54_e90]

got it sorted, thanks for help guys

[rkreimer10]

Originally Posted by crazythedon

got it sorted, thanks for help guys

Glad you got it sorted, but would you care to share what exactly the fix was.

[Impac]

Originally Posted by rkreimer10

Glad you got it sorted, but would you care to share what exactly the fix was.

Egs needs to be default coded after update, and if you have paddle shifters dsc needs default coding also