[shortfella]

Hello everyone! I had faulty abs pump on my e90 so I had to replace the pump. I wanted to keep old module but couldn't separate it from the pump itself because screws are probably inside the module and I didn't want to take it apart. Now I got rid of the faulty pressure sensor code I had before but I need to change vin on the new module. I am quite confused now because I couldn't find any straight forward thread that worked for me. When I tried doing it with Winkfp I couldn't find dsc_87 folder (which my module is), there is only dsc81, dsc84, dsc89 and dsc90. Any help would be appreciated. Sorry if my English is bad

[sdbmwcoding]

Don’t need to flash it, just code dsc with ncs expert (sg_codieren) and then use inpa or ista to run dsc calibration