|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Ediabas.ini settings for most
|
|
04-17-2021, 04:45 PM | #1 |
Captain
278
Rep 657
Posts |
Ediabas.ini settings for most
Hi Guys,
Does anybody know what settings to change in the ediabas.ini file to enable MOST (icom B) for flashing? Have changed the settings to enable icom but I'm struggling to find the setting to enable MOST. |
04-18-2021, 10:04 PM | #3 |
Lieutenant General
1911
Rep 13,103
Posts |
I don't believe there is one . It should be taken care of with Icom.
Never heard anybody even ask this question. Also the issue with Icom not working over K/D can is K/D can is unstable with high speed. And contains no buffer circuitry. https://www.bimmerforums.com/forum/s...-P-actually-do descriptions of the cables are in the above thread. "An ICOM switches between ADS, dual K-Line, K-CAN, DCAN, MOST, and Ethernet automatically; and supports them all." From the above link Last edited by ctuna; 04-18-2021 at 10:15 PM.. |
Appreciate
1
F31B48278.00 |
04-18-2021, 10:57 PM | #4 | |
Captain
278
Rep 657
Posts |
Quote:
https://www.bimmerforums.com/forum/s...T-WINKFP-et-al |
|
Appreciate
0
|
04-19-2021, 02:17 AM | #6 |
Captain
278
Rep 657
Posts |
Quote:
I changed one setting under CONFIGURATION. Change INTERFACE=stdobd to INTERFACE= REMOTE Then further down in that file i put the IP address of the icom as shown in itool radar, then i was able to connect to the car (tested with inpa first) reprogrammed the rad2 no problems. Thanks for the responses ctuna. |
Appreciate
0
|
04-27-2021, 08:21 PM | #8 | |
Private First Class
38
Rep 144
Posts
Drives: 2006 BMW 325i (E90)
Join Date: Feb 2020
Location: NJ
|
Quote:
Start up iTool Radar and Reserve the ICOM slot Use EasyConnect after iTool to select the MOST bus ASYNC setting and LOCK ICOM (this will change your edibas.ini file to the correct settings for ICOM A+B) Continue with WinKFP, it should work perfectly now. |
|
Appreciate
1
F31B48278.00 |
Bookmarks |
|
|