[BUFFLARS12]

hey everyone
In the process of bluetooth retrofit. had everything installed, car was programmed.
now i am getting SOS error, worked when i picked up the car.
Everything was hooked up except the mic pi switching behind the glove box...
i went to do this today because the mic was not working and there is many more wires in the plugs then explained.

It says to move "So I just have to take the glove box out, the bracket holding the glove box and a small screw driver to flip the connector tabs open and swap clear from pin 4 to 3. yellow 5 to 1 and black 6 to 2"
In all of those slots there are wires, and they are the same colors as the ones that are supposed to be moved.
do these need to be spliced togehter?
ANyone have access to diagrams?
this is driving me nuts
when i look inside the plug it appears that only 5 pins are to be used.

[freefly]

1