[jaytes]

Originally Posted by alddiem415

Hey! When u installed ur vrsf, was it solid light or blinking light?
What color was the light.

Where did u connect yours?
O2 sensor side plug or harness engine side?

I just installed mine yesterday.. i installed it on the 02 sensor side. Light was solid blue then it will blink then back tp solid..

Just want to make sure i got it right..

I haven’t reach 50miles yet though

It was a blinking light, i connected it to the O2 sensor side using positaps and then the shop tried welding the wires (in case it was a connection issue). It should be blinking if your car is running.

[alddiem415]

It’s blinking when the car is running.i used positaps as well. I cleared the codes then drove again for like 10 miles. Scanned it and got the same code but SES light hasn’t come up yet.

[alddiem415]

Before installing vrsf dp fix, i was on mhd stage 2..

Everything was complete except
Catalyst not available
Heated catalyst not available
Secondary air system not available
A/C ref not available

Will this pass NJ emission?

I think Catalyst not available due to catless dp

[yuyuyuyu]

Originally Posted by alddiem415

Before installing vrsf dp fix, i was on mhd stage 2..

Everything was complete except
Catalyst not available
Heated catalyst not available
Secondary air system not available
A/C ref not available

Will this pass NJ emission?

I think Catalyst not available due to catless dp

No, you'll fail for not having cats ready/available.