|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
jb4 Help
|
|
11-19-2019, 01:29 PM | #1 |
Private
8
Rep 60
Posts |
jb4 Help
I have a 2009 e90 335xi and recently installed Jb4 this past weekend. The car runs and drives fine but the mobile app and logs are showing 8.1 psi boost pressure at idle and off throttle on maps 1,4 and 5. WOT on map 5 will jump up to about 22-24 psi but will not switch to map 4. Could anyone provide any insight to why this may be? Car is basically stock with bms intake. Has almost 55k miles and recently had a walnut blast.
Also car will show codes 3100, 29f3, 2abd, 2abc, 2d2e, 2b2c on cold start, once the car warms up i am able to clear all codes except for 29f3. Any insight will be much appreciated. |
11-21-2019, 03:18 PM | #3 |
Private First Class
54
Rep 174
Posts |
If you want my two sense, If you keep having issues with it (seems to be a bad install/unit) you should take it out and run MHD. Cheaper/easier and turn key solution.
|
Appreciate
0
|
Bookmarks |
|
|