|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
Cars Stalls Then Does Not Start For A While
|
|
07-19-2018, 02:10 PM | #1 |
First Lieutenant
27
Rep 290
Posts |
Cars Stalls Then Does Not Start For A While
277A hot film air mass meter, signal: electrical fault
29D0 intake air temperature sensor, electrical: short circuit to B+ 29D2 intake air temperature sensor, signal change: too fast 290A intake air temperature sensor: multiple fault 2BE9 cylinder injection cutout: pressure too low in high-pressure 36FD dme main relay, plausibility: prematurely dropped out Was driving the car pretty hard and everything was fine. On the way home I went to accelerate a little bit and the car gave me half engine and cut out all throttle responses and eventually the engine died out and would not start for around 30 minutes. Unplugged and replugged the battery and that seemed to have worked, but not sure. If you got any incite let me know please haha this issue is driving me nuts |
07-19-2018, 02:25 PM | #2 |
General
8108
Rep 18,797
Posts
Drives: BMW
Join Date: Nov 2005
Location: Anaheim, CA
|
Aftermarket intake installed?
__________________
Tom G. | european auto source (eas)
email: tom@europeanautosource.com · web: https://europeanautosource.com· tel 866.669.0705 · ca: 714.369.8524 x22 GET DAILY UPDATES ON OUR BLOG · FACEBOOK · YOUTUBE · FLICKR · INSTAGRAM |
Appreciate
0
|
Bookmarks |
Thread Tools | Search this Thread |
|
|