|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
How to clean the old oil under valve cover
|
|
11-01-2024, 01:06 PM | #1 |
Private
14
Rep 80
Posts |
How to clean the old oil under valve cover
Hello
My car was leaking oil from valve cover gasket area for a while, and finally the gasket was replaced. The dealer did not clean the gunk of oil, and it's still there. I like to clean the oil that way if there is an oil leak, I know right away. Can I just spray oil de greaser to remove those gunk? Spray water down in the engine bay? Do I need to remove the under cover to let water escape to the floor? Some of areas are hard to reach, and I am wondering spraying de greaser is enough to remove those oil stain and gunk. Any advice is welcome. Thank you. |
11-02-2024, 08:43 AM | #3 |
Brigadier General
4240
Rep 3,263
Posts |
As suggested, remove the splash tray then clean the area with a degreaser and a nylon brush. The tray over the exhaust manifold should be bright aluminum and I remember how satisfying it was to clean after I DIY'd the VCG.
__________________
|
Appreciate
1
codeterrorist186.50 |
Bookmarks |
Thread Tools | Search this Thread |
|
|