|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
Airbag resister - what am I doing wrong?
|
|
12-09-2018, 02:07 PM | #1 |
Banned
471
Rep 996
Posts |
Airbag resister - what am I doing wrong?
|
12-09-2018, 03:05 PM | #2 |
Lieutenant General
1911
Rep 13,103
Posts |
If you did this without disconnecting the battery you will get
an error that requires a BMW diagnostic setup or coding setup to clear the error. Once the error is registered it has to be reset with this software. There are procedures on how to do this when going to a new wheel that includes putting the airbag back in . My guess is you are trying to fool the car into to thinking there is and air bag there. This is not usually a question for the stereo board. Where did you get the procedure for installing whatever you are installing? From the second to last picture just a comment that the quick dissonnects for the two resistor are not insulated with tape in the picture. I assume you are doing this before tucking them away. Last edited by ctuna; 12-09-2018 at 03:27 PM.. |
Appreciate
0
|
Bookmarks |
|
|