Using BimmerCode to disable sos warning

firestonetires · 06-23-2021, 01:07 PM

Just installed an aftermarket radio on a 2011 e92. Looking for the file and code to disable the sos message on the dash using BimmerCode code. I found the them for an e60(below) , but the file is not there for an e92.

Instrument cluster
Export mode
3001 CC_ID_Sperre
CC_AKTIVIERUNG_5
Custome value
Byte 5
Change value from FF to F7

I don’t have file 3001. Does anyone know the file and code to change?

Thanks

mike5124 · 06-30-2021, 01:25 PM

You can try this in KOMBI module:

TCM_ALIVE_MONITOR -> nicht_activ
TCM_ID_MONITOR -> nicht_activ

If that doesn't work, you need VO coding, which BimmerCode cannot do. This requires a laptop, BMW standard tools, and a K+DCAN cable.

You add +TELD to VO and default code TCU, KOMBI, and either CAPPL, CIC, or RAD2 (just the first two modules are needed in your case).

If this is too much trouble, I can setup up the programs and do this remotely as well, just send me a PM. Best of luck.

- Michael

TunafishE93 · 06-30-2021, 11:22 PM

You can VO with Protools also, easier platform to work with.

06-23-2021, 01:07 PM	#1
firestonetires Registered 1 Rep 3 Posts Drives: E92 Join Date: Oct 2015 Location: St. Louis iTrader: (0)	Using BimmerCode to disable sos warning Just installed an aftermarket radio on a 2011 e92. Looking for the file and code to disable the sos message on the dash using BimmerCode code. I found the them for an e60(below) , but the file is not there for an e92. Instrument cluster Export mode 3001 CC_ID_Sperre CC_AKTIVIERUNG_5 Custome value Byte 5 Change value from FF to F7 I don’t have file 3001. Does anyone know the file and code to change? Thanks
	Appreciate 0 Tweet Quote

06-30-2021, 01:25 PM	#2
mike5124 Private First Class 38 Rep 144 Posts Drives: 2006 BMW 325i (E90) Join Date: Feb 2020 Location: NJ iTrader: (0) Garage List 2006 BMW 325i [0.00]	You can try this in KOMBI module: TCM_ALIVE_MONITOR -> nicht_activ TCM_ID_MONITOR -> nicht_activ If that doesn't work, you need VO coding, which BimmerCode cannot do. This requires a laptop, BMW standard tools, and a K+DCAN cable. You add +TELD to VO and default code TCU, KOMBI, and either CAPPL, CIC, or RAD2 (just the first two modules are needed in your case). If this is too much trouble, I can setup up the programs and do this remotely as well, just send me a PM. Best of luck. - Michael
	Appreciate 1 san40k21.00 Quote

06-30-2021, 11:22 PM	#3
TunafishE93 Major 418 Rep 1,154 Posts Drives: BMW 335i Join Date: Dec 2019 Location: NV iTrader: (0)	You can VO with Protools also, easier platform to work with.
	Appreciate 0 Quote