Bricked DME via MHD Flasher

julianubico · 07-22-2022, 08:14 PM

So I have an 2010 335i e92 and I was flashing a full flash with MHD. I had the ignition on but the car wasn't fully on (fuel gauge was not reading) so the flash had failed. I tried to redo the flash and it was working, until towards the end it said packet failed to write and after that it is now impossible to communicate with any module in the car. I tried with WINKFP, TOOL32, INPA, ISTA- everything and it is not possible to even connect to the vehicle. I am lost on what to do now, is the DME even repairable at this point? Or will I need to get another DME

mfran615 · 08-06-2022, 04:50 PM

What did you end up doing here?

07-22-2022, 08:14 PM	#1
julianubico Registered 0 Rep 3 Posts Drives: 2010 BMW 335i E92 Join Date: Jul 2022 Location: FL iTrader: (0)	Bricked DME via MHD Flasher So I have an 2010 335i e92 and I was flashing a full flash with MHD. I had the ignition on but the car wasn't fully on (fuel gauge was not reading) so the flash had failed. I tried to redo the flash and it was working, until towards the end it said packet failed to write and after that it is now impossible to communicate with any module in the car. I tried with WINKFP, TOOL32, INPA, ISTA- everything and it is not possible to even connect to the vehicle. I am lost on what to do now, is the DME even repairable at this point? Or will I need to get another DME
	Appreciate 0 Tweet Quote

08-06-2022, 04:50 PM	#2
mfran615 Private 11 Rep 65 Posts Drives: 2011 335is 6MT Join Date: Dec 2015 Location: OH iTrader: (0)	What did you end up doing here?
	Appreciate 0 Quote