|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
BT codes detected
|
|
05-06-2009, 12:44 AM | #1 |
**1er Lover**
10
Rep 201
Posts |
BT codes detected
Hey guys, ran a scan today after receiving my BT tool and got the following:
2F9E: 2F9E Termic oil level sensor Error will not cause a warning light Error is not currently present Test conditions have been completed Signal or value below threshold Event 1 Odometer 12136kms 7549miles Engine speed 704.00 rpm control unit inside temp 49.50 C voltage K1. 87 14.42 V status motor control 2.00 0-n These next two came up throughout the log multiple times: 1015: Error will cause a warning light Error is not currently present Test conditions have been completed 0083 Error will not cause a warning light Error is not currently present Test conditions have been completed Timeout Signal or value below threshold I've run searches and googled and I havent found anything on these codes...WTF? I've got a JB+ @ 95% w/solenoid bypass + BMS DCI, I did not have anyother codes show up, including tuner codes. Anyone, help? __________________
__________________
*'08 135i vert Jet Black/Coral Red*Premium + ///Msport + JB3 + BMS DCI* (retired )
*'11 135i dct Le Mans/Black Premium + ///Msport + JB3 Stg.1 + BMW Perf. Exhaust + HPA Foam Filter |
09-07-2009, 12:05 PM | #2 |
Colonel
165
Rep 2,875
Posts |
Hey, I'vegot those two exact codes yesterday while scanning my car..........Also have no f@#$ing idea what caused them.
Please, someone chime in!! TIA
__________________
'08 AW E90 335i PROcede V5 | BMS DCI | RR DPs | ETS FMIC | FORGE DVs | Stett CP | Vanguard | PSS10 |
Appreciate
0
|
09-07-2009, 12:13 PM | #3 |
Brigadier General
675
Rep 4,080
Posts |
I've had 2 oil level sensors replaced so far by BMW. My oil temp indicator would drop down to 0 and I would get a warning light. Yes - replaced oil level for temp problems.
|
Appreciate
0
|
09-07-2009, 01:35 PM | #4 |
only in it for the torque - awuleth'umshini wami
50
Rep 425
Posts
Drives: sapphire black 335i
Join Date: Apr 2009
Location: nomad
|
kingnonis - I had code 1015 last week....this is how it happened. I have been running JB1.4 for a month now on various maps...with no issues. One morning last week i street raced another guy while the car was still cold on map 7 and as the car was boosting and rev limiter hitting 5000rpms i got a limp mode... BT tool gave me 1015 code and the explanantions i got said it was "tuner" related & "boost reached target". I cleared code and never had it again - learn't yet again not to race on high maps with a oil temp not warm enough. I then had a few more street races the next couple of days on map 7 with "hot" engine (oil temp 120 degrees - nicely in the middle) and no issues...by the way won all 4 races. I hope i got this figured...but i think... it is Jb1.4 related...map 7 is simply crazy power...but hope there is another reason
__________________
|
Appreciate
0
|
Bookmarks |
|
|