|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
How to get the new Idrive software?
|
|
06-08-2007, 09:25 PM | #1 |
Private First Class
15
Rep 176
Posts |
How to get the new Idrive software?
How are you guys doing it? My dealer says they just will not upgrade it, so what are you telling them, so they update it?
Thanks |
06-08-2007, 09:30 PM | #2 |
Major
17
Rep 1,074
Posts |
Tell them that you're iDrive goes too slowly or that your arrow display goes away during navigation. I don't remember what exactly it was but there is a service bulletin stating the exact reason for the upgrade. They must do it, if not I would go to another dealership.
|
Appreciate
0
|
06-08-2007, 11:15 PM | #3 | |
168
Rep 2,114
Posts |
Quote:
|
|
Appreciate
0
|
06-09-2007, 04:13 PM | #5 |
Colonel
101
Rep 2,317
Posts |
Here you go You can read up more on this thread...
http://www.e90post.com/forums/showth...t=54505&page=9 SI B 61 03 05 General Electrical Systems April 2007 Technical Service This Service Information bulletin supersedes S.I. B61 03 05 dated March 2007. designates changes to this revision SUBJECT Software Errors Corrected with Progman MODEL E90, E91, E92, E93 (3 Series) Vehicles produced up to March 30, 2007 SITUATION Customer may complain of the following: The following software errors were corrected with the release of Progman 25.01.00 (Target data Status E89x-07-03-520). Only software errors that are corrected with the last 2 Progman versions will be listed. CCC (Car Communication Computer) equipped vehicle, the SDARS (Satellite Radio) stored station list is intermittently empty since programming with Progman V25.00.00. Poor RTTI (Real Time Traffic Information) reception. The CID (Central Information Display) is constantly displaying "Transferring Messages" since programming with Progman V25.00.00. After vehicle programming PDC (Park Distance Control) FC 9e28 is stored. Carry out a power cycle (ignition Off/On) and clear the fault memory. The following software errors were corrected with the release of Progman 25.00.00 (Target data Status E89x-07-03-515). If there is an incoming telephone call while SVS (Voice Input System) is active it is not possible to accept or reject the call. A loud humming noise can be heard from the auxiliary fan when the vehicle is idling. The automatic transmission enters "Failsafe" mode during a 5-4 downshift. EGS fault "AF8D – ratio monitoring 5-4 gearshift plausibility" is stored. CCC: The programmable diamond MFL button does not work when set to "Next entertainment source" when vehicle is in motion. CCC: The customer occasionally has poor radio reception after the vehicle was programmed with Progman V23.x or V24.x. The speedometer and tachometer needles shake when the vehicle is idling. CCC: Slow response to inputs made when using controller after startup. CCC: A high frequency whistling noise intermittently can been heard in radio mode CCC: Navigation system pop-up arrow display missing. Refer to SI B84 61 06. CCC: CD/CDC track advances after key cycled. Refer to SI B65 32 05. SDARS (Satellite radio) receiver fault "A537 – Sat aerial short circuit" is stored. The following software errors were corrected with the release of Progman 24.00.00 (Target data Status E89x-06-12-510). |
Appreciate
0
|
06-09-2007, 05:31 PM | #6 | |
Private First Class
15
Rep 176
Posts |
Quote:
|
|
Appreciate
0
|
06-12-2007, 01:51 PM | #8 |
First Bimmer
4
Rep 102
Posts |
if they still say no, tell your SA that you are going to call BMWNA and put a complain against them!! they HAVE TO DO IT! they might say we dont have that software tell them u will tell bmwna that the dealership is not up to date.
__________________
.
|
Appreciate
0
|
06-12-2007, 02:29 PM | #9 |
Colonel
101
Rep 2,317
Posts |
Has anyone heard of their DVD or CD just randomly spinning up? I got in my car the other day to get something. Key was not in my pocket but in the house and I heard the CD spinning up. Happens all the time on the road too. I think it is the DVD. Is this a "reason" to upgrade. My pop-up seems to work so I can't use that excuse.
Thanks |
Appreciate
0
|
Bookmarks |
|
|