[alex_k_145]

I there a way I could plug in and test an msd80 dme with it outside the car? I saw some images where you could wire it into the KD can connector and then provide 12v power to the ignition and power pins. However would this allow me to read codes using the can low and high lines and would I be able to use a scope to see if the bsd pins ar outputting a signal?

Thanks in advance.

[ptpending]

probably yes
you can dig here


there is also similar thread on our forum
https://www.ebay.com/itm/16651659721...Bk9SR4qd-aC0Yw

you can also use such a device

[alex_k_145]

Thanks for the info!