[armin0676]

Hello can someone help me to code variable redline on my 320d m47? I have already rebuilt my speedometer so that the motor is soldered in and moves. But I can't get it to code correctly with perfect toolbox. Thanks in advance

[LMB335IS]

Originally Posted by armin0676

Hello can someone help me to code variable redline on my 320d m47? I have already rebuilt my speedometer so that the motor is soldered in and moves. But I can't get it to code correctly with perfect toolbox. Thanks in advance

If you're looking for it to work like it would in a petrol car, it won't. The best you can do is make it sit at one spot. Shouldn't be too difficult to figure out with some trial and error.

[armin0676]

But it was already done here by someone on 330d but I can't find the thread anymore. But it was here in the forum

[LMB335IS]

Originally Posted by armin0676

But it was already done here by someone on 330d but I can't find the thread anymore. But it was here in the forum

They got the redline to move to a stationary point. It will not rotate with coolant/oil temp like it does in non M/M petrol cars. I've spent plenty of time trying to get to work for customers but it never happened. Alpina D cars have it but I'm sure it's because they run different DDE software.

[armin0676]

I found it here. Can you tell me how it is there?
https://www.e90post.com/forums/showthread.php?t=1335532

[LMB335IS]

Originally Posted by armin0676

I found it here. Can you tell me how it is there?
https://www.e90post.com/forums/showthread.php?t=1335532

I'm familiar with this thread. They never said they got it to work properly, only that they moved the redline to a specific rpm. Look, I've built over 1000 custom E9x clusters, so I might know what I'm talking about. You're welcome to continue to try as much as you want though. If it was going to work it would have already. Once you activate it through Perfekt it works, after that it's just fine tuning the min and max with the values.

[armin0676]

Ok so it's not possible to use it.